Great value to get biscuiting with Torquata’s Biscuit Slot Cutter Kit
Perfectly designed for clean andquick cutting, these 4mm thick slot cutter assemblies – available in 1/4in and 1/2in shanks – comewith the standard bearing for #20 biscuits plus the bearings to reduce the cutting depth touse on the smaller #0 and #10 biscuits.
Biscuits are available in three common sizes to suit different sized work pieces with the most common size being the largest the #20 biscuit.
- #20 biscuit – 56 x23mm
- #10 biscuit – 53 x19mm
- #0 biscuit – 47 x15mm
About Biscuit Joinery
Biscuit joining is a simple, quick and effective method of joining two work pieces developed byLamelloin Switzerland. You simply put the work pieces together, mark a common point on both and use that as a reference to cut a4mmslot approximately halfway down the edge of the timber.
Glue the slots on both work pieces, pop a biscuit in and run glue along the remainder of the edge of the joint then clamp it together. The biscuit absorbs the glue, swelling and locking the work pieces in together tight. For thicker materials, you can use two biscuits in the same location at differing heights increasing the joint strength even more.
It is a very simple, quick and effective method of assembly that is used commonly in the joinery industry.
Unconditional Satisfaction Guarantee
