Torquata Spiral Upcut Router Bits Solid Carbide 1/2in Shank

Spiral bits work perfectly on all forms of solid timber, along, across and on end-grain and leave razor-sharp edges on melamine, veneered boards, ply, MDF and chipboard.

Torquata solid carbide spiral bits begin life as extra-hard C4 micro grain carbide, ground using sophisticated 6-Axis C.N.C. to grind their spiral geometry. The precision of the spiral and hardness of carbide allows for a very sharp edge and typically longer edge sharpness. A straight bit can’t compete with that. The geometry and top point allow you to plunge into your work like a drill, using a constant shearing action when making the cuts.

Used handheld, upcut bits eject the waste up towards the shank with a smoother edge on the bottom of the cut, Used in a table, upcut bits eject waste under the table with a smoother top edge.

If you’re looking for the opposite chip ejection and edge finish you need to check out the Downcut Spiral Bit range.