iVAC MSC Pro Switch Controller for Automated Dust Control

The iVACMSC Pro Switch Controller for Automated Dust Control

How the system works

Each iVAC MSC Pro Switch can accept signals from up to 8 different Tool Plusses to form a system more than enough for a typical workshop. If you are in a larger, multi-user workshop, the iVAC MSC Switch can be programmed to work on four different radio frequency bands – allowing you to set up to 32 different work stations.

Tools can be stationary, such as a cabinet saw, thicknesser and bandsaw,or hand held, such asrouters and circular saws. In fact any tool that has a power cordcan interact with theiVAC system.

The advantage of the MSC Controller

The iVACPro MSC (Magnetic Switch Controller) has been specifically designed to work with NVR (No Volt Release) switches that are typically standardon home workshopdust extractors and are required in larger commercial or teaching workshopsin Australia. The MSC Pro works by controlling a fully-magnetic NVR switch.This still provides you with full NVR switch protection and allows the MSC Pro to operate. Most three-phase dust extractors already have a magnetic NVR switch controlling the power to the unit and therefore this iVACMSC Switch is available separately and wired into the existing magnetic NVR Switch.

The MSC Pro then controls the power flow within the NVR switch to operate the dust extractor. In the event of system power loss, the NVR switch and MSC Pro will need to be reset, which means you still have the full safety of an NVR switch built into the system.

Simply programmed to make dust extraction easy!

The MSC Pro can be programmedfor a minimum run time or to switch off after a set period of time once a power tool has been turned off. This will ensure that the dust extractor is not being switched on and off in a way that could damage the expensive induction motors found in dust extractors as well as being able to clear out the dust lines once operations have been completed.

While there are simple remote switching mechanisms that can be purchased to control your dust extractor remotely, iVac is the only fully automated dust control system that allows for quick, easy installation and operation of a complete dust extraction system in any size workshop – that can also be retrofitted to existing systems. Plus with the added flexibility of being able to redesign and adjust the system to suit your needs.

Once you setup the system, you can forget about how your dust system is working and get on with the important task of getting to work – in a cleaner and safer environment.

Having Trouble with designing your iVAC solution?

We at Timbecon pride ourselves with the high level of customer service. Should you need any help with iVac products. Please contact us and let us assist.